Values between 10db and 20db typically produce the best results. The higher the value, the more noise is removed. This feature specifies how much noise you want to remove. Sounds the most natural out of all the modes. ![]() ![]() Mode 3: The least-susceptible mode for artefacts.Removes less noise than Modes 0 and 1, but produces fewer artefacts. Mode 2: The standard mode for fast PCs.The results may at times not be as good as with Mode 0. Mode 1: Similar to Mode 0, but less susceptible to errors.(This mode is susceptible to flange distortion and squeak artefacts.) Mode 0: This mode tends to produce the best results.Now you can start making settings changes to get the best possible noise reduction result for your material.ĭon't worry if two different modes sound exactly the same. The noiseprint you created before should still be there. Go back to "Tools" > "Noise Reduction".Select the entire file by double-clicking it.Click "OK" to close the Noise Reduction window.Click the "Preview" button on the right twice.Ī graphic representation of the noiseprint will appear.The "Capture noiseprint" checkbox is also located in the Noiseprint tab. Place a check mark next to "Capture noiseprint".A one-second range is normally large enough. ![]() The selected range does not need to be as large as the one in the picture.
0 Comments
Leave a Reply. |